Has anyone managed to pull the Telemetry data from the FrSKY Sensor Hub onto their 9x? I'm using a ERsky9x which doesn't have support for it out of the box and a quick search has not revealed any sample projects so I've come here.
I am hoping to use the temperature sensor, RPM, GPS and Variometer but could do with a leg-up, understanding that a PDF is already out there.
9X FrSKY Sensor Hub Telemetry
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: 9X FrSKY Sensor Hub Telemetry
FrSky telemetry, including hub data, is in ersky9x. You just need to connect the serail data from the Tx module to the serial port on the ersky board.
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: 9X FrSKY Sensor Hub Telemetry
Perhaps I flicked the FrSky reciever switch or have put the cable round the wrong way because when I connect the temperature sensor I don't see where in ersky9x the reading should be output. So far I can only see an area for voltage. I have connected the sensor hub to A1, should I connect it to A2.
Re: 9X FrSKY Sensor Hub Telemetry
The sensor hub must be connected to the DATA port (G TX RX).
Re: 9X FrSKY Sensor Hub Telemetry
Oh right. the one that the jumper on it. thanks
Is there a section for amps and x y z variometer?
Sent from my GT-P1000 using Tapatalk 2
Is there a section for amps and x y z variometer?
Sent from my GT-P1000 using Tapatalk 2
Re: 9X FrSKY Sensor Hub Telemetry
The jumper should actually be on either A1 or A2 if you want to measure the receiver's supply voltage with that input.
Yes all hub values can be displayed AFAIK.
Yes all hub values can be displayed AFAIK.