taranis center point drift

Love the 9x? Use FRSky? Post your questions and answers here!
Post Reply
burobaaje
Posts: 3
Joined: Thu May 11, 2017 11:45 pm
Country: -

taranis center point drift

Post by burobaaje » Thu May 11, 2017 11:51 pm

I set my center points using subtrim to 1500. Check later and the roll is moved about 25 points down to 1480 or so. Re-trim and it moves again. Do I need to reflash the firmware? Have a gimble problem? I think it caused a couple of crashed last flights. Thanks!

burobaaje
Posts: 3
Joined: Thu May 11, 2017 11:45 pm
Country: -

Re: taranis center point drift

Post by burobaaje » Fri May 12, 2017 4:27 am

Update: In another test, I set all at 1500 and then rolled right and left a couple of time. Instead of returning to 1500 or no input it stayed at 1482. Anyone know what could cause this?

User avatar
Kilrah
Posts: 9552
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: taranis center point drift

Post by Kilrah » Sat May 13, 2017 7:44 am

Defective gimbal? Maybe just the pot not well tightened in place...

User avatar
bob195558
Posts: 1872
Joined: Sun Dec 16, 2012 7:24 pm
Country: United States
Location: New England, Vermont
Contact:

Re: taranis center point drift

Post by bob195558 » Sun May 14, 2017 12:40 am

I did have a loose pot on one of my Taranis Gimbals and to fix it from moving, I used a little Super Glue on it.
You may want to upgrade your Gimbals to the M9 Gimbals.


Bob B.
ErSky9x on Taranis, Sky9x, 9Xtreme, Er9x on 9x with Smartieparts Programmer with TelemetrEZ Board
(http://openrcforums.com/forum/viewtopic.php?f=95&t=7182).
CR10 3D Printer: (http://openrcforums.com/forum/viewtopic.php?f=85&t=10702)

burobaaje
Posts: 3
Joined: Thu May 11, 2017 11:45 pm
Country: -

Re: taranis center point drift

Post by burobaaje » Sun May 14, 2017 11:14 am

Thanks to both, will open the taranis and check gimbal, but thinking seriously about going M9.

dudley

Post Reply

Return to “The FRSKY Forum”