openrcforums

Hi all,
A few days ago when i was training with my 250 racer, i had a crash and lost fpv broadcast. After checking and troubleshooting all the electronics i found out that the part in the pic bellow was gone as you can see in the pic below the first one.
I would like to know what part is that so i can try to replace it.
Does anybody know what part is?
Thx

Most likely a 22uH inductor. Seems it took the top layer of the PCB with it though.

BTW are you happy with that cam? These HD thingies usually have noticeable lag while not providing any actual resolution advantage (limited by the analog link anyway). Need to use the SDI out to make use of it.

The part is similar to the one near by with the 220 writing, i assume you noticed. Yes top gone.
No, too much lag (126 ms), so definetly not good for fpv racing. Should have read more about fpv cams suitable for racing.
SDI?????
Purchased this one for replacement. Very good feedback about the runcam one.

Do you think this ones will be ok?

Inductors look OK if they're the right size, can't know.

The coax connector at the bottom left in your pic is likely for an HD-SDI digital video stream, that's what I referred to.

Oh ok, never used it, since my dominator hd2 dont reproduce in hd, only the fov is better/wider than others. The inductors are 4x4x2mm, so very small, but i also dont know the amps, so i contacted surveilzone to see if theres is a reasonable possibility of out of warranty repairs. This cost me 43€ for nothing.
They advertise it as fpv, but they dont fit for fpv, because also the cmos sensor provides jelly video.
What to do?

I talked to surveilzone about the situation, and guess what? They will replace it, i only have to pay the postage back and forth.
Ill be damn...

Good costumer servce then

João

Yes. Gotta have luck some time. Just one crash and the cam is gone, no justice.