Hi João,
Do you have a diagram or photo of the back of the single board version?
I want to make sure the shunts and opens are in the correct spots.
Thank you,
Joe
Hi João,
Not sure I understand, I believe I always used that transistor, which if I remember, switches the backlight..
No need for speaker mod the beeper signal is fed to the arduVoice board, and it will be played through its speaker.One question is do you have to do the speaker mod for this to work or will installing the ArduVoice bypass the old OEM beeper/speaker
Go to "Model Setup / General", Scroll down to "Volume Control" and select the Pot you want to control the volume with.
Hi Joao, thanks for your advice....I had already done that but have now realised that altering the setting of the volume control (P1) only takes effect for the “next” voice file to be played....I had initially thought it would work “during” a voice file.
Hi, I haven’t got an FTDI adapter installed inside my Tx, leaving a connector in the battery bay to be able to plug one in if required in the future, so no that doesn’t have to be connected.hackerjoe wrote: ↑Thu Mar 22, 2018 10:26 pm OK everything is installed and the sound board powers up.
I removed OEM beeper and transistor.
I get a beep when powering up from ArduVoice.
I enabled M'sound serial in hardware mode and changed mode sound to Megasound.
How do I setup what file plays for whatever switch is toggled ? Or is that the program that the Arduino is running? If that's the case I have no sound.
Does the FTDI adapter need to be connected? I think I had RX & TX connected to it but no ground. I'm hooking up the ground as I post this.
Joe
I do know what you are talking about.. When I am working on something I completely forget about the time. That is why people see me replying here on the forum at any time of the night or day I had already a few people asking me if I sleep at all
It's been quite a while, and Mike could probably answer this better than me, but I think there is a special Er9x version only for the voice over serial. This version is only for the m64 processor..My other TH9X is an Atmega64 can you do the sound card in it or is there not enough memory in it?