How to configure telemetry to beep?

[laffsj]

I have a 128 cpu and 9XR DJT module, I am trying to configure the telemetry to the battery, it appears on the screen 9XR values ​​are all correct, but I can not set the alarm to beep same battery by setting the values ​​in the telemetry. How do I fix this and hear the alarm? Can someone help me? I'm with er9xfrsky 811

[Daedalus66]

If you have a 9XR transmitter as you seem to suggest, it cannot run ersky9x. You must use ER9x.

[jhsa]

Nigel, He said "er9xfrsky 811" not ersky9x

@laffsj

You have to configure a custom switch. For example for voltage assuming you have a voltage sensor connected to A1

S1 v<ofs A1 10.5V

Now go to the safety switches menu and choose a high channel.

CH10 A SW1 warn1

A - audio

SW1 - is the custom switch 1 (S1) that you programmed before.

Warn1 - Is one of the several sounds/beeps you can choose.

[Kilrah]

But he posted in the ersky9x section
Moved now.

[jhsa]

ha, I didn't see that

[Daedalus66]

ha, I didn't see that

we were both only seeing part of the picture. But I'm still not sure what the problem is.

[jhsa]

He just wants to cofigure the alarms to beep with the telemetry.

Sent from my GT-I9195 using Tapatalk

[laffsj]

Jhsa.
Thank you for the help, worked perfectly

[jhsa]

Glad you got it working. Have fun.
Joao

Sent from my GT-I9195 using Tapatalk

[laffsj]

I am needing some help when you guys taught me to set the voltage sensor to alarm everything went well and usually works until today.
Now I'm with a new aeormodelo battery life and uses it, did all the setup to alarm as everything was done, however I noticed that the sensor is anternando voltage, when I calibrate it to tell me the correct voltage, this voltage spending time begins to rise, turn off the RX and call back again to score correctly but already begins to rise again, anyone know what might be happening?

[jhsa]

what battery, what settings, and what sensor, and where it is connected?

João

[laffsj]

The battery life is a zip of 6.6 v 3600 mah, the sensor is the FrSky Battery Voltage Sensor - FrSky Telemetry System and is connected on port A2.
When I turn on the TX RX shows for example a voltage of 5,5 and the time goes up and comes to stay in v 7,5v

[laffsj]

More information than I tried to do. The sensor is FBVS-01 model, there places to change it welds according to the voltage that will work, and already gone through all the problem continues, connecting the radio receiver and it shows eg 6.6 v but spending a few minutes it goes to 7.5 v, the more time passes the more value rises.
Anyone know what might be happening?