Macadamia wrote:I DID USE blackmoon's schematic in first time. But now my hardware is made using schematic with r44. So it's up to date. I don't wire RX with D8 as long as it is not used.
Sorry, my english isn't perfect, I misunderstood used <--> use ...
Maybe it was too late for me
The schematic from r44 (r49 !) has no changes, so this is working ...
Macadamia wrote:
No problem after 3 hours of flight...
Hope and pray ...
Macadamia wrote:
I try to understand why Hubsan motors start immediately. I think once model is binded motors should stay stopped... Is it possible to do monitoring via TX pin output? (baudrate ?) It's may be possible to track throttle channel...
Hubsan X4 binds automatically after powering TX and Quad, so you only have to power your TX first, then your X4. Maybe there's the failure ?
What are your settings for CH8 ?
My settings: (er9x-r788)
EDIT MIX CH8
Source -> FULL
Weight -> -25
... (no changes)
Switch -> ON
... (no changes)
I power first my beloved FS-TH9X TX, then my (my wifes) Hubsan X4 (v1 relabeled Revell in Germany), no short spinning of motors, no other mysteria ...
I tried the other way too, power the X4 first, then my TX, but no failures,
it binds and flies like it should.
But be safe, first power TX then RX (as always!).
hmmm ... I don't know, but ...
How about your Module power source ? Maybe some voltage break after powering your TX?
The new code (r52) works with my Hubsan X4 and my Veroboard Module (r44) without trouble ...
Macadamia wrote:
And about Graupner module, shipping costs to France are too expensive... After research JRPA615 seems to be restock in US shops. I'll see that later.
Sorry for my misunderstanding, but from Germany to France are sooo much postage?
If I buy something within EU (e.g. GB) I only pay 1-3 Euro per shipping ...
Hope you get your Module right, I have no other ideas ... sorry