openrcforums

Hi all,

I would try to make a wiper fonction on a servo motor with er9x software for my truck, is that possible ?
+ I would like to add a fonction that the speed of the wiper is proportional with the speed of the throttle (that'll be the paradise for me)

If that is possible, thx a lot by advance for some exemple

Traxx

As a starting point, try the "Servo Test" template (in eepe, or on the 9X if you have a '128 processor).
This makes a servo sweep from end to end slowly. You may need to set "Fast Mix Delay" on to get a reasonable sweep rate.

Mike