Need help for wiper fonction

er9x is the best known firmware. It has a superb range of features and is well supported by the community. Well worth trying out.
Post Reply
traxxalu
Posts: 1
Joined: Wed Mar 07, 2018 7:06 pm
Country: -

Need help for wiper fonction

Post by traxxalu » Wed Mar 07, 2018 7:13 pm

Hi all,

I would try to make a wiper fonction on a servo motor with er9x software for my truck, is that possible ?
+ I would like to add a fonction that the speed of the wiper is proportional with the speed of the throttle (that'll be the paradise for me)

If that is possible, thx a lot by advance for some exemple :)

Traxx

User avatar
MikeB
9x Developer
Posts: 15651
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: Need help for wiper fonction

Post by MikeB » Wed Mar 07, 2018 10:16 pm

As a starting point, try the "Servo Test" template (in eepe, or on the 9X if you have a '128 processor).
This makes a servo sweep from end to end slowly. You may need to set "Fast Mix Delay" on to get a reasonable sweep rate.

Mike
ersky9x/er9x developer
The difficult we do immediately,
The impossible takes a little longer!

Post Reply

Return to “er9x”