Hi Forum,
Can someone help with code for assigning the gear switch to control a stabilizer on channel 5?
Here is my code:
CH5 100FULL GEA
Thanks!
Mike
Code for Gear Switch
-
- Posts: 1844
- Joined: Tue Dec 27, 2011 8:22 pm
- Country: -
- Location: Ottawa
Re: Code for Gear Switch
To assign a two position switch to channel 5, the mix you have there is one way to do it.
The other way would be to use the switch as the source. That would look like
CH5 100 sGEA
Leave the "switch" setting blank (---) when you use a switch as source.
Does this answer your question, as you've already given one answer?
The other way would be to use the switch as the source. That would look like
CH5 100 sGEA
Leave the "switch" setting blank (---) when you use a switch as source.
Does this answer your question, as you've already given one answer?
Re: Code for Gear Switch
Thanks Da!
What I have doesn't work. I'll upgrade firmware and see if the sGEA works.
Mike
What I have doesn't work. I'll upgrade firmware and see if the sGEA works.
Mike
Re: Code for Gear Switch
Found out the flight stabilizer was looking for the opposite polarity. I set in -100, and it works!