Code for Gear Switch

er9x is the best known firmware. It has a superb range of features and is well supported by the community. Well worth trying out.
Post Reply
Cburg
Posts: 18
Joined: Sat Dec 27, 2014 1:10 am
Country: -

Code for Gear Switch

Post by Cburg »

Hi Forum,

Can someone help with code for assigning the gear switch to control a stabilizer on channel 5?

Here is my code:

CH5 100FULL GEA

Thanks!
Mike
;)

Daedalus66
Posts: 1844
Joined: Tue Dec 27, 2011 8:22 pm
Country: -
Location: Ottawa

Re: Code for Gear Switch

Post by Daedalus66 »

To assign a two position switch to channel 5, the mix you have there is one way to do it.

The other way would be to use the switch as the source. That would look like

CH5 100 sGEA

Leave the "switch" setting blank (---) when you use a switch as source.

Does this answer your question, as you've already given one answer?
Cburg
Posts: 18
Joined: Sat Dec 27, 2014 1:10 am
Country: -

Re: Code for Gear Switch

Post by Cburg »

Thanks Da!
What I have doesn't work. I'll upgrade firmware and see if the sGEA works.
Mike
Cburg
Posts: 18
Joined: Sat Dec 27, 2014 1:10 am
Country: -

Re: Code for Gear Switch

Post by Cburg »

Found out the flight stabilizer was looking for the opposite polarity. I set in -100, and it works!

Post Reply

Return to “er9x”