X9E and OpenTX 2.2.0 RC10 (N362)

[Gunnergolly]

Have just installed OpenTX 2.2.0 RC10 (N362) onto my X9E and i can't edit the models once they have been loaded into OpenTx.

I can run the simulator for a specific model, i can read/write the Firmware and EEPROMS to and from the radio, i can look at the global radio settings so OpenTx is communicating ok with my X9E.

However when i double click on a model nothing happens, can somebody please confirm that there is a problem with the X9E usng 2.2 RC10.... or maybe tell me what i'm doing wrong.

Thanks...

[Gunnergolly]

Eventually found out what the problem was...... make sure that you have the massstorage box ticked in the "settings" option before you download and install the firmware, working fine now ...