Dual FLVSS lowest cell.

[Oldbuzzard]

Can someone please advise.
I have 2 FLVSS volt sensors monitoring 2 6s lipos wired in parallel.
The telemetry has discovered 2 instances of CELS as expected (1 and 2 but they both have the same ID 0300 ?)
Do I need to detect and set alarms separately for each unit or will setting one to LOW find the lowest cell from either pack?

I know in the old firmware I just had to detect it once.

Thanks

[Kilrah]

Lowest will give you the lowest of that pack. You can then use an extra "minimum" sensor to find the lowest of both.

[Oldbuzzard]

Actually Kilrah, been trying all afternoon to set this up. I cant change the second FLVSS to read cell. The option cell sensor remains --- and I cant change it.
I mean whichever sensor I change first is ok but I cant change the second one.
and please, what to the square brackets around a value mean?

[Kilrah]

What are you trying to "change" exactly?
Square brackets means no data has been received for this sensor for more than I believe 10 seconds.

[Oldbuzzard]

Think I may have sorted it.
After sensor detection I was trying to edit the sensor (FLVSS) to give the lowest cell voltage instead of the total.
It now seems to work if I copy the original sensor and edit that to 'cel' and 'lowest'.
Editing the original seemed to stop the sensor telemetry.

[Kilrah]

You must create a new Calculated sensor yourself to extract the Lowest cell, same for the Minimum.
Don't touch the discovered ones beyond renaming them for easier recognition.

[Oldbuzzard]

Yes thats got it. Thanks for rapid replies.
I noticed if I disconnect the battery from the FLVSS balance port the last cell voltage freezes, therefore no warning is generated. Not ideal.