Throttle Hold on Turnigy 9x with Open TX FW

[vk4apn]

Have just flashed Turnigy 9x with latest Open TX FW. I wish to use the throttle switch to isolate throttle until ready to fly ( electric Plane) this was called throttle hold in org FW. I have looked thru all menu options but cant spot how to do this. It is possible that I did not select the right options in the FW compile? Sorry if this has been covered before, but all refs to hold/sticky haven't helped yet.
Thank You
Paul

[Kilrah]

Look for "throttle cut" and "sticky throttle cut" in the forum. There are even templates for them on the radio if you have templates enabled.

The simplest method is an "override CHx" special function set at -100 on your throttle channel.

[denvoyager]

No, that is for the 9xr! NOT the 9x