Some questions for you on telemetry utilization on the PRO. I have been running opentx now for awhile and recently upgraded from the 9xr to the pro radio capable of voice. I have set up the voice to my best ability utilizing the taranis examples, but it is somewhat difficult at times since taranis is a different radio with different options. My telemetry is running and i have discovered all sensors that i have installed.
My question is - I have set up 4 critical warning conditions using logical switches a<x where x is the minimum pre-set value. These would be rpm, fuel, rssi, alt, and when i turn on the radio it only warns me on the last logical switch condition. In my case the alt condition, although all conditions meet the requirement of warning. Shouldn't i hear all warnings?. If I simulate the radio i see all switch conditions lit meaning that they are set, and yet again only the last is spoken. If i am underutilizing the radio settings can you please point me into the right direction of description, otherwise how can I achieve this?
The next logical question would be - If ts possible (am sure it is since there is lots of youtube showing the display with), how do I set up telemetry pages on the PRO display, taranis has a page button. Thank you for your assistance.
9xr pro - opentx 2.1 telemetry
Re: 9xr pro - opentx 2.1 telemetry
Special functions
Announcements/Play
Each line at the end has an option on when to play the announcements.
When active
Once not at start up
Once
Every x seconds
Check each line and see what they are set to.
http://rcdiy.ca/opentx-transmitter-firm ... functions/
Announcements/Play
Each line at the end has an option on when to play the announcements.
When active
Once not at start up
Once
Every x seconds
Check each line and see what they are set to.
http://rcdiy.ca/opentx-transmitter-firm ... functions/
RCdiy.ca
Stay Safe & Have Fun
OpenTX Manual http://rcdiy.ca
Paying it forward by sharing my Lua scripts, documentation and videos.
Stay Safe & Have Fun
OpenTX Manual http://rcdiy.ca
Paying it forward by sharing my Lua scripts, documentation and videos.
Re: 9xr pro - opentx 2.1 telemetry
yes - i did set those - for engine and rssi i have set repeat every 2 sec, and for alt and fuel its every 15.
and it seems its my fault - apparently the alerts that i have created for some reason do not play. Funny it seemed to play when i first tested them but no matter thats just another challenge. I substituted other voice commands and it all worked.
The screens are the next challenge.
and it seems its my fault - apparently the alerts that i have created for some reason do not play. Funny it seemed to play when i first tested them but no matter thats just another challenge. I substituted other voice commands and it all worked.
The screens are the next challenge.