Limiting servo travel in one end

openTx has introduced a range of new features, ideas and bling. It is fast becoming the firmware of choice for many users. openTx will run on ALL current hardware platforms, including the gruvin9x and sky9x boards. Work has already started to support the new FrSky X9D radio!
Post Reply
AndersL
Posts: 1
Joined: Tue Feb 06, 2018 9:07 am
Country: -

Limiting servo travel in one end

Post by AndersL »

Hi

Is it possible to assing a knob say S1 for limiting servo travel in one end?
I would like to do it on-the-fly and not i setting mode.

User avatar
Kilrah
Posts: 11107
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: Limiting servo travel in one end

Post by Kilrah »

You can do it in several different ways using GVARs.
User avatar
jhsa
Posts: 19480
Joined: Tue Dec 27, 2011 5:13 pm
Country: Germany

Re: Limiting servo travel in one end

Post by jhsa »

You don't even need GVARs, just use a multiply mix under the mix that controls the servo

João

Sent from my BLN-L21 using Tapatalk

My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9

Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW

Post Reply

Return to “openTx”