hi all
open tx 2.2
Hurricane aircraft
i set up buddy box for 2 taranis 9xd (not plus), with quick take-back and runs very well, no issues been running this for 3 years or more
what i want to know is it possible to hand over flaps and gear to buddy box as well as standard controls?
is possible to do this ?
ric
buddy box help required
Re: buddy box help required
Yes all controls up to 8 using ppm and the cable... I set it up allow the eFlite oops/recover button available on the student Tx as well.
Look at the chanel monitor screen/ outputs screen and watch the values for the 1st 8 chanels change as you change the values on the student Tx. I've not done it recently so my memory is a bit fuzzy...
Look at the chanel monitor screen/ outputs screen and watch the values for the 1st 8 chanels change as you change the values on the student Tx. I've not done it recently so my memory is a bit fuzzy...
RCdiy.ca
Stay Safe & Have Fun
OpenTX Manual http://rcdiy.ca
Paying it forward by sharing my Lua scripts, documentation and videos.
Stay Safe & Have Fun
OpenTX Manual http://rcdiy.ca
Paying it forward by sharing my Lua scripts, documentation and videos.
Re: buddy box help required
also i having issues with the trims as well
i hand over to slave but the trims values are not being handed of from master what am i doing wrong
i hand over to slave but the trims values are not being handed of from master what am i doing wrong
Re: buddy box help required
You typically do NOT want the student to trim the model.
Re: buddy box help required
Radio Settings > Trainer
Two options
+= (SUM) This way you retain your trims (but when you move your sticks it adds to student stick position)
:= (Replace) This way the student Tx would need to have trims adjusted
If you want to use Replace then go to the
Main View > CHANNELS MONITOR (press page)
Observe the chanel output values when stick center
Pass controls to the student, trim student Tx till output valuse match what they were when the instructor's Tx has control.
I haven't done this is some time so please excuse me if not correct... Let me know and I'll try and do a full test on equipment...
Two options
+= (SUM) This way you retain your trims (but when you move your sticks it adds to student stick position)
:= (Replace) This way the student Tx would need to have trims adjusted
If you want to use Replace then go to the
Main View > CHANNELS MONITOR (press page)
Observe the chanel output values when stick center
Pass controls to the student, trim student Tx till output valuse match what they were when the instructor's Tx has control.
I haven't done this is some time so please excuse me if not correct... Let me know and I'll try and do a full test on equipment...
RCdiy.ca
Stay Safe & Have Fun
OpenTX Manual http://rcdiy.ca
Paying it forward by sharing my Lua scripts, documentation and videos.
Stay Safe & Have Fun
OpenTX Manual http://rcdiy.ca
Paying it forward by sharing my Lua scripts, documentation and videos.