Throttle warning on different switch

[kennlicht]

Hello to all. I'm new to this forum and here is my first question:

I don't use the throttle stick but a switch (SA) instead to start the motor of my model. I know I can configure a "switch warning" for that switch. But I would really appreciate if I could also get a "throttle warning" if the switch is not in its idle position.

I haven't found a way to configure that behaviour in OpenTX 2.2... Is it possible though?

[OctavioS]

You will have to make copy and rename the throttle warning audio file to the a proper folder, which i think its \sounds\en and configure the warning to that switch.

[kennlicht]

The sound is not the problem. I want to get the warning ...

Please have a look onto the attached screenshot: If I set "Throttle Source" to CH04, which is mixed from switch SA, it is used for Timer 2 correctly. But the "Throttle Warning", which I enabled, reacts on the stick position, and not on CH04.

No chance?

[jhsa]

Can't you change the channel source to a channel in openTX?

João

EDIT: Oh, I see, it might react to the input, not to the channel output itself..
Then I'm afraid you are stuck

João