I have OpentTx on a 9x and I'm slightlty confused/forget.
In which OpenTX menu screen do I finally limit the actual throw of a servo?
Mixer screen? or Limits screen? What is the effective difference in limiting the weight in the mixer screen vs the limits screen?
Thanks for humoring me!
*Edited for increased clarity.
Simple question: Where is actual servo limit set in OpenTX menues?
-
- Posts: 213
- Joined: Tue Jun 16, 2015 2:05 am
- Country: United States
- Location: durham, nc
Simple question: Where is actual servo limit set in OpenTX menues?
Last edited by interestingfellow on Thu Jun 01, 2017 6:08 pm, edited 1 time in total.
Re: Simple question: Where is actual servo limit set?
Normally you first use the limits to conform to your model mechanics (ensure servos don't bind and travel the same amount on both sides), then adjust desierd stick response (= actual throws) in Inputs.
-
- Posts: 213
- Joined: Tue Jun 16, 2015 2:05 am
- Country: United States
- Location: durham, nc
Re: Simple question: Where is actual servo limit set?
Which screen is "inputs"? I dont have one labled as such.
I do have screens labled "dr/expo" "mixer" and "limits"
Ver 2940
I do have screens labled "dr/expo" "mixer" and "limits"
Ver 2940
Re: Simple question: Where is actual servo limit set in OpenTX menues?
Ah, 9X, D/R for you then.
-
- Posts: 213
- Joined: Tue Jun 16, 2015 2:05 am
- Country: United States
- Location: durham, nc
Re: Simple question: Where is actual servo limit set in OpenTX menues?
Aye. I tried to upgrade to the newer build and it had some bugs so I downgraded to maintain reliability, and then never looked at upgrading again. I'll be switching to ER9X/Ar9x soon, anyway.
Thanks again, y'all!!!
Thanks again, y'all!!!
- bob195558
- Posts: 2377
- Joined: Sun Dec 16, 2012 7:24 pm
- Country: United States
- Location: New England, Vermont
- Contact:
Re: Simple question: Where is actual servo limit set in OpenTX menues?
Find erSky9x firmware (ersky9x for SKY board and AR9X board) for AR9x here: (http://www.er9x.com/).
And use eepSkye on your PC.
Bob B.
And use eepSkye on your PC.
Bob B.
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).