OpenTX 2.2.0 9XR-PRO MultiModule
-
- Posts: 23
- Joined: Fri Oct 09, 2015 2:50 am
- Country: -
OpenTX 2.2.0 9XR-PRO MultiModule
Can someone tell me what the status of the multimodule is with OpenTX 2.2.0 on the 9XR-PRO as I'm struggling for info, it's in the build options and when I flash OpenTX 2.2.0 all the options are there but its not connecting to the MultiModule (red flashing) but everything works fine in erSky9x
-
- Posts: 1844
- Joined: Tue Dec 27, 2011 8:22 pm
- Country: -
- Location: Ottawa
Re: OpenTX 2.2.0 9XR-PRO MultiModule
First thing to check is that the module is making good contact with the pins. Press it firmly into the bay and hold while turning on.
-
- Posts: 23
- Joined: Fri Oct 09, 2015 2:50 am
- Country: -
Re: OpenTX 2.2.0 9XR-PRO MultiModule
tested the module on ersky9x and everything works as it should i think i need to flash a different firmware onto the multimodule with inverted serial
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: OpenTX 2.2.0 9XR-PRO MultiModule
The serial output to the multi module is not affected by inverting the telemetry, only the data from the module changes.
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
-
- Posts: 23
- Joined: Fri Oct 09, 2015 2:50 am
- Country: -
Re: OpenTX 2.2.0 9XR-PRO MultiModule
changing opendrain to pushpull fixed it