Hello,
I had just purchased the Spektrum DSM2 AIRMOD with AR7010 JR-Compatible SPMMSJR720, and was having real problems binding it to my Blade Nano Qx. After some frustrating time I finally checked out the protocol section on the receiver and
Protocol:
Proto : PPM
Channels : 8CH
Time: 400uSec
Frame Length: 20.0Sec
1St chan
Pulse Polarity : NEG
Attached is my Model that works with my Nano Qx.
It has the following.
Rudder: is Custom curve for me on curve 4 (I am learning and keep rotating while using the throttle)
Curve 1: -60,-30,0,30,60 to 1 of 3 on Flight Mode Switch
Curve 2: -80,-40,0,40,80 to 2 of 3 on Flight Mode Switch
Curve 2: -100,-50,0,50,100 to 3 of 3 on Flight Mode Switch
Train Switch: Toggles Acro / Safe Mode
Throttle Switch: Enables disables Throttle
Countdown: 5 minutes tied to throttle (My nano flys about 5 minutes per charge)
Voice: On flight mode change Throttle Switch and Chirp when in or out of Acro mode.
Mixers:
CH01 +100%Thr
CH02 -100%Ail Switch() Curve(c1)
-100%Ail Switch() Curve(c2)
-100%Ail Switch() Curve(c3)
CH03 +100%Ele Switch() Curve(c1)
+100%Ele Switch() Curve(c3)
+100%Ele Switch() Curve(c2)
CH04 -100%Rud Curve(c4)
CH05
CH06 +100%FULL Switch()
Turnigy 9X Spektrum DSM2 AIRMOD with AR7010 JR-Compatible SPMMSJR720
Turnigy 9X Spektrum DSM2 AIRMOD with AR7010 JR-Compatible SPMMSJR720
- Attachments
-
- NanoQX.eepm
- (3.41 KiB) Downloaded 686 times
-
- Posts: 1844
- Joined: Tue Dec 27, 2011 8:22 pm
- Country: -
- Location: Ottawa
Re: Turnigy 9X Spektrum DSM2 AIRMOD with AR7010 JR-Compatible SPMMSJR720
All channels should be set to +/-80% limits to equal Spektrum pulse widths (except low throttle should be -100 to ensure arming). Channels 2 and 4 should be set to INV to get correct control direction
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk