Hello,
i'm using a JR radio with a DSM2 DM9 module since years... But now i'm trying to use my 9X with Open9x and the same DM9 module.
i spent quite a long time looking for why the binding was impossible between my AR6255 RX and my TX... with 1855 released
i find that "by default" the PPM rate of 22,5 was not good for the DM9.
i put just to try 20 and it works now well. This point can be interesting for some people.
But, now, i would like to know if there is a way to find the best PPM rate for the DM9 module? does it even exists?
best regards
Benjamin
DM9 Module
Re: DM9 Module
nobody to give a clue?
pas de bol!
pas de bol!
Re: DM9 Module
See my post on DM9 connector problem to see if this might be your problem.
Re: DM9 Module
With my DM9 module I use PPM 8CH 22.5ms 400us. The only thing changed from the default is the 400us. And even then it still bound and worked fine, however on my BNF aircraft the centering was wrong without 400us.
-Gohst
-Gohst
Re: DM9 Module
I have a DM9 and a 9XR on the way (= noob).... can you explain why you aren't using the DSM2 only or DSM2/DSMX protocol ?
I haven't used either but this is documented for both Open9x and ER9x
Thanks
I haven't used either but this is documented for both Open9x and ER9x
Thanks
Re: DM9 Module
The DM8/9 were made to be used with old xxMHz JR radios, that supplied a PPM signal to their module slot. So that's just what it's made to work with.
Re: DM9 Module
Thank you.
I will experiement when it gets here ... I purchased the module (SPMMSJR720 - DSM2 AIRMOD), I just checked the manual and you are correct, it does state the PPM mode is required.
Thanks for the advice.
I will experiement when it gets here ... I purchased the module (SPMMSJR720 - DSM2 AIRMOD), I just checked the manual and you are correct, it does state the PPM mode is required.
Thanks for the advice.
Re: DM9 Module
I can get up to 9 channels with the DM9 and the Lemon Rx...
Re: Sv: DM9 Module
As far as I understand you can only get 8. 9 channels do not fit within the standard PPM protocol used between module and radio.
- Rob Thomson
- Site Admin
- Posts: 4543
- Joined: Tue Dec 27, 2011 11:34 am
- Country: United Kingdom
- Location: Albury, Guildford
- Contact:
Re: DM9 Module
That is correct. The 9ch can only work in the PCM mode. Which the DM9 does not support.
Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!