Hi Guys
I want to use a simple 12 channel function for operating a multi rotor with ER9X and the TGY 9X radio. I have the first 4 channels for the usual Rud. Ele. Ail. Throt. and then 4 more channels for different flight modes etc. So far so good, that was relatively easy.
But then I want to use 3 more channels to use the 3 pots for controlling the camera gimbal. No mixes just straightforward channel outputs. My problem is that I can't figure out how to set this up using the mixer and the special sw. page.
Any clues?
Simple 12 channel set up.
Re: Simple 12 channel set up.
Go to .model setup/protocol and and increase the number of channels sent by the tx to 12. Don't forget to increase the frame length number accordingly. Do you actually have a 12 channel RF module?
João
João
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW