openrcforums

I'm looking for a blade 400 3d hell setup if anyone has one that they can share please?

Here's a file I used to get my Blade 4003d flying. Mine had EMAX metal gear servos on the cylic and I've no idea of they actuate in the same direction as the stock ones. Everything else was stock.

Hello,
I would appreciate using your setup, but I'm not able to open it with EEPE (already renamed as *.hex, *.eepe, *.eepm, *.bin).
Thanks.

You can't open it because that file is not for eepe.. it is for companion which is the editor from opentx. Unfortunately companion uses the same file extension as eepe and eepskye, making it impossible to see which eeprom belongs to each firmware.. It is time the opentx developers change the file extension really

João