Building a Camera/Lighting cntrl Transmitter for Multi-Rotor

[lancersdad]

I am drawing up some flow chart sheets hoping to attach to a new thread in some format... Having been creating a single camera/lighting control transmitter for my multi-rotors ( both hex and quad )... I am quite familiar with some concepts I have drawn in the flow chart having watched months of tutorials on the creating of a wide variety of rudder/ aileron/ elevation configurations... Having as of yet found any definitive videos for my purposes...
I am wanting to replace a couple of the pots with some of the FrSky 6 Position Mode Flap Switches. Using some custom curves to configure that switch.... since this conversion is for Camera/Lighting switch controls.. not flight control nor pod control over the Joysticks in any fashion.... '
If you are around I'd appreciate your feedback and opinion on what I am attempting to accomplish...

One pot being the feed/control to 3 toggle switches.
The 2nd throw not having a value of ( 0 ) but rather ( ! )

The only creative curves is between the pot and each toggle switch...
So far all I am using is 11 channels... no flight control...
I'm going to attach some more images detailing what each channel is for.
With this engineered I'll create some videos detailing how the switching was achieved...