Nitro governor multispeed selector issue

Programming your 9x using the stock firmware that comes with the radio. (Note. This is for the th9x, not the X9R)
Post Reply
urbanfly
Posts: 1
Joined: Fri Jan 04, 2013 10:50 am
Country: -

Nitro governor multispeed selector issue

Post by urbanfly »

I have Turnigy 9x with standard firm ware. Can someone help on how to program/connect nitro governor to flight mode switch (3 position switch) The switch needs to be linked with the V curves mixes so you can select three diffrent headspeeds for the 3 diffrent modes of flight. At the moment I have set the gov on Hover throttle switch, works but shuts off when inverted due to thinking you are throttling down & not refering to v curve position which is actually speeding up.
Do I have to reflash firmware & if so is it 100% possible to do the above. I have searched templates but could not really see this form of setup
I would really appreciate advice from someone who has set up nitro heli with this firmware or new open9x source firmware.
Thankyou.

Post Reply

Return to “stock firmware (fly sky th9x)”