I'm trying to setup my turnigy 9x with stock firmware to send 8 channels to the Ardupilotmega and I was trying to understand how it works.
In the configuration I can assign to the AUX channels, ch 5 to ch 9 from the output of the following switches and potentiometers:
- GEAR (2 pos switch)
- THRO HOLD (2 pos switch)
- HOV THRO (pot)
- PIT TRIM (pot)
- HOV PIT (pot)
But I'd like to be able to use also the other switches because I only need one continuous channel, but I cannot find a way to assign the other switches available on the radio:
- AIL (2 pos switch)
- ELE (2 pos switch)
- RUD (2 pos switch)
- Flight mode (3 pos switch)
- TRN (momentary switch)
Is there a way to do so? Or should I upgrade to a different firmware?
I'm pretty newbie on programmable RC TX... if they cannot be assigned, what are they used for? Or if this is very basic stuff I should know, can you please forward me to some site with explanations?
Thank you
Simone