I just received my 9x yesterday. There is something I can't figure out:
When I go to E.Points setting, there are two columns of percentage settings, but I can only go through one of the two percentages for every channel. When I click up or down buttons it jumps through one setting - usually just in the right column, but sometimes on the left (it happens on two channels in airplane configuration). So I can't edit both endpoints of any channel! What am I doing wrong? Or if it's a bug - is there a workaround???
Can't program both End Points
-
- Posts: 14
- Joined: Tue Aug 14, 2012 2:47 pm
- Country: -
- Location: Toronto
- Contact:
Can't program both End Points
Roman Bershadsky
web designer, composer
http://www.romandesign.ca - award-winning Toronto Web Design Studio
My music: http://www.moebiuscat.com - Moebius Cat - listen and download free
web designer, composer
http://www.romandesign.ca - award-winning Toronto Web Design Studio
My music: http://www.moebiuscat.com - Moebius Cat - listen and download free
Re: Can't program both End Points
If you try to set the end points for aileron:
To set the left end point, move the aileron stick left, and edit with +/-. To edit the right side, move the stick right.
To set the left end point, move the aileron stick left, and edit with +/-. To edit the right side, move the stick right.
-
- Posts: 14
- Joined: Tue Aug 14, 2012 2:47 pm
- Country: -
- Location: Toronto
- Contact:
Re: Can't program both End Points
Ha! It was that simple! I feel stupid. You are correct, it works fine. Thanks!
Roman Bershadsky
web designer, composer
http://www.romandesign.ca - award-winning Toronto Web Design Studio
My music: http://www.moebiuscat.com - Moebius Cat - listen and download free
web designer, composer
http://www.romandesign.ca - award-winning Toronto Web Design Studio
My music: http://www.moebiuscat.com - Moebius Cat - listen and download free
-
- Posts: 1
- Joined: Fri Feb 08, 2013 8:37 pm
- Country: -
Re: Can't program both End Points
Kilrah wrote:If you try to set the end points for aileron:
To set the left end point, move the aileron stick left, and edit with +/-. To edit the right side, move the stick right.
Thank you very much Kilrah, I'm just programming my new 9X and I was frustrated by this same issue. I was about to decide I had a bad unit. I'm really happy to have found this answer. Now I feel a lot better about my 9X.