Help with QX90C (DSM) model creation

Programing help and example for all firmwares based on thus's th9 firmware.
Post Reply
ando1
Posts: 2
Joined: Sun Feb 26, 2017 4:49 pm
Country: -

Help with QX90C (DSM) model creation

Post by ando1 »

I am hoping someone can help me as I have been searching and have not been able to find a solution. I have an X9D+ with the multi-protocol 4in1 module installed. I also made sure to enable the DSM protocol was enabled during the 4in1 programming. The issue I am experiencing is when trying to fly my QX90C with integrated DSM RX. I created a new model on the X9D and can successfully bind to the QX90C, however the motors do not spin up after arming them. I read multiple threads with similar issues but the users were using the Orange-X module in the X9D. I also read that I needed to set the X9D to TAER and set limits to 80%. Being new to the hobby and the X9D, I think I have successfully done this, but I still cannot get the motors to spin. I have attached the model that I am using. Can someone take a look at it and let me know what is wrong?
Attachments
QX90C_Model.pdf
(25.52 KiB) Downloaded 273 times

User avatar
jhsa
Posts: 19480
Joined: Tue Dec 27, 2011 5:13 pm
Country: Germany

Re: Help with QX90C (DSM) model creation

Post by jhsa »

The multi Protocol module, when used with BNF stuff, normally translates the channel order to the one each of the toys need.
Try changing your radio channel order in your radio's mixer to AETR.

João
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9

Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
Post Reply

Return to “er9x / gruvin9x / th9 based firmwares”