9XR Pro + Multiiprotocol + Inductrix Rate Mode mixer issues
9XR Pro + Multiiprotocol + Inductrix Rate Mode mixer issues
I've installed ersky9x rev 218 on my 9xr pro and can bind and fly with my inductrix using the multiprotocol module. One thing I can't get to work is acro mode/rate mode. I'm trying to bind channel 6 to my TRN switch in the mixer but I can't find the combination to make it work. I have soldered the connections to make the multiprotocol work in radio rather than turning the dial. When I go back to using the dial and PPM mode, the sTRN switch works for channel 6 but I can't get it to work in multi(serial) mode. Any ideas?
- MikeB
- 9x Developer
- Posts: 17990
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: 9XR Pro + Multiiprotocol + Inductrix Rate Mode mixer issues
When using the serial mode, what value do you have in the option setting?
If it is 0, then you have selected 4 channels only.
Mike.
If it is 0, then you have selected 4 channels only.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: 9XR Pro + Multiiprotocol + Inductrix Rate Mode mixer issues
I've done some additional testing in the megathread on this module over at rcgroups. Found that DSMX doesn't bind at all, but DSM2 works fine once I select option 6. Also, the stock firmware worked best, updating it broke it again. I guess I'll just stick with what's on it now instead of updating until they get some more ironed out
Re: 9XR Pro + Multiiprotocol + Orange receivers
I have installed Banggood multiprotocol module, soldered the tx and rx jumpers, loaded Ersky pr219,
Binding to orange receiver only possible with DSMX option. Getting only 4 channels. What option numbers to get 8 channels or more?
PPM to Naze32 shows correct channel order (TAER) but plugging in servors to receiver the order is EATR. Also dropping signal often - is this the DSMX binding?
Binding to orange receiver only possible with DSMX option. Getting only 4 channels. What option numbers to get 8 channels or more?
PPM to Naze32 shows correct channel order (TAER) but plugging in servors to receiver the order is EATR. Also dropping signal often - is this the DSMX binding?
Re: 9XR Pro + Multiiprotocol + Orange receivers
OK - found the problem with 4 channels only. The options was set to zero (4 channels). Change that to 2 and getting 6 channels.
Still getting ETAR on the servos - don't understand why.
Also not possible to set option to greater than 2 (6 channels). Sure would like to bind with more channels for PPM.
Still getting ETAR on the servos - don't understand why.
Also not possible to set option to greater than 2 (6 channels). Sure would like to bind with more channels for PPM.