Hi all,
Very New to the Taranis. I have been able to setup a basic model, gone through all the tutorials I can, but am stuck on setting up the choke on SF.
Can anyone Pleeeaaassseee point me to a walkthrough that will give full travel of a servo on a switch. I have been able to get half of the travel one way but can't figure out how to get the servo monitor to show travel both on SF(Up arrow) and SF(down arrow)
Thanks in advance,
Dan
Taranis X9D Plus / OpenTX / Choke Settings
-
- Posts: 8
- Joined: Fri Jan 15, 2016 10:42 pm
- Country: -
- MikeB
- 9x Developer
- Posts: 17990
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Taranis X9D Plus / OpenTX / Choke Settings
Just set the source of the mix to SF?
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
-
- Posts: 8
- Joined: Fri Jan 15, 2016 10:42 pm
- Country: -
Re: Taranis X9D Plus / OpenTX / Choke Settings
Thankyou. I had the source set as SF but also had a switch defined. Once I put the switch to ---, all works.MikeB wrote:Just set the source of the mix to SF?
Mike.
Thanks!!!