Ok so i have my ternigy 9XR with er9X installed and set my telemetry display set.
I am trying to set some alarms but there is no sound. To be more specific i have set some A1 and A2 channel values, connect my receiver with a power supply and start reducing input voltage below the values i have set, i can see the voltage dropping on my display but there is no alarm.
I have set int. frsky alarm to off.
Setting alarms question
- MikeB
- 9x Developer
- Posts: 17990
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Setting alarms question
With Int. FrSky alarm OFF, then you are using the alarms in the Tx module.
The TxRSSI and RxRSSI alarms are stored in the Tx module. If these settings are staying as you you set them, when you power the Tx off and on, then this confirms your connections to the Tx module are OK. (You have connected both Tx and Rx to the module haven't you?).
Mike.
The TxRSSI and RxRSSI alarms are stored in the Tx module. If these settings are staying as you you set them, when you power the Tx off and on, then this confirms your connections to the Tx module are OK. (You have connected both Tx and Rx to the module haven't you?).
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: Setting alarms question
CustomSwitches:
CS1 v<ofs A1= 5V (or whatever you want to set)
CS2 v<ofs A2= 11V (or whatever voltage)
safety switches:
CH9 A CS1 Warn1 (or whatever other alarm you like)
CH10 A Warn2 (or whatever other alarm)
Thix could vary depending on the er9x version you have installed.
João
CS1 v<ofs A1= 5V (or whatever you want to set)
CS2 v<ofs A2= 11V (or whatever voltage)
safety switches:
CH9 A CS1 Warn1 (or whatever other alarm you like)
CH10 A Warn2 (or whatever other alarm)
Thix could vary depending on the er9x version you have installed.
João
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
Re: Setting alarms question
Ok i applied the settings and alarms now work, ofcourse no matter of what sound i choose warn 1, warn 2 etc i can only hear One single beep.
Pretty difficult for someone that he is not an expert to think and imagine what er9x can do!
I also check that the low signal alarm works by default as before, a really useful feature of Frsky.
Pretty difficult for someone that he is not an expert to think and imagine what er9x can do!
I also check that the low signal alarm works by default as before, a really useful feature of Frsky.