KK 2.1 setup on er9x

Programing help and example for all firmwares based on thus's th9 firmware.
Post Reply
User avatar
Malcurin
Posts: 61
Joined: Fri Apr 20, 2012 7:58 pm
Country: -
Location: Matamata New Zealand
Contact:

KK 2.1 setup on er9x

Post by Malcurin »

Greetings, I am trying to setup a KK2.1 board and i have all the channels setup and working how i want, I am just trying to setup a self level switch ( on by default and off when i flick it ) if this is possible I'm new to multirotor flying any help would be fantastic
Im also looking to use the 3 position switch as a rate switch for learning , default is 25 middle is 60 and bottom position will be 100 , i saw the template earlier but cant find it again,

thanks
Mike
Turnigy 9x with ER9X and back light FrSky DHT 8ch DIY, FLD-02 Telemetry Display Screen
AXN with 6x4 prop .... AWESOME!!!!!!!
Canterbury Sailplanes Jazz 60 and Eraser 60
Dyna-flight Butterfly ( under construction )

User avatar
Malcurin
Posts: 61
Joined: Fri Apr 20, 2012 7:58 pm
Country: -
Location: Matamata New Zealand
Contact:

Re: KK 2.1 setup on er9x

Post by Malcurin »

For the self level on a KK 2.1
Set Source = FULL, weight = -125, Switch = GEA then Exit - sets self level on
Set Source = FULL, weight = 0, Switch = !GEA then Exit - sets self level off

and i also got the rates thing too , found then after a few hours of looking lol
Turnigy 9x with ER9X and back light FrSky DHT 8ch DIY, FLD-02 Telemetry Display Screen
AXN with 6x4 prop .... AWESOME!!!!!!!
Canterbury Sailplanes Jazz 60 and Eraser 60
Dyna-flight Butterfly ( under construction )
Post Reply

Return to “er9x / gruvin9x / th9 based firmwares”