Set Vector gain with pot?
Posted: Fri Sep 08, 2017 3:13 pm
I have a vector flight controller and I am trying to use a pot (p1) to set the gain.
I need the pot to go from 0-100% over the full range (throw) of the pot. So far all I have only been able to do is 0-100% over half the range of the pot.
I am using a Frsky X9D plus radio.
Any suggestions?
tom
I need the pot to go from 0-100% over the full range (throw) of the pot. So far all I have only been able to do is 0-100% over half the range of the pot.
I am using a Frsky X9D plus radio.
Any suggestions?
tom