Set Vector gain with pot?

Programing help and example for all firmwares based on thus's th9 firmware.
Post Reply
farmertom
Posts: 43
Joined: Fri Feb 15, 2013 2:54 pm
Country: -

Set Vector gain with pot?

Post by farmertom » Fri Sep 08, 2017 3:13 pm

I have a vector flight controller and I am trying to use a pot (p1) to set the gain.
I need the pot to go from 0-100% over the full range (throw) of the pot. So far all I have only been able to do is 0-100% over half the range of the pot.
I am using a Frsky X9D plus radio.
Any suggestions?
tom

User avatar
MikeB
9x Developer
Posts: 15562
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: Set Vector gain with pot?

Post by MikeB » Fri Sep 08, 2017 4:39 pm

Weight 50%, offset 50% ?

Mike.
ersky9x/er9x developer
The difficult we do immediately,
The impossible takes a little longer!

Post Reply

Return to “er9x / gruvin9x / th9 based firmwares”