openrcforums

Posted: **Sun Jun 25, 2017 6:40 am**

Hi, everyone,
I'm setting up my 9xPro, and I am at the 'setting D/R and Expo' page. I'm using the 'RUD' setting.
In expo,I can adjust the right hand 'set' i.e. the upper part of the graph line, but don't know how to move the cursor to the left-hand number,i.e. the lower part of the graph.
I cannot reset the 'Hi' at all, How do I change that,please.Help!?please!
Den, Wales

Posted: **Sun Jun 25, 2017 7:53 am**

Hold the stick on the relevant side.

Posted: **Sun Jun 25, 2017 8:56 am**

Without holding the stick to one side both sides should change values together.. If that is not happening, please calibrate the sticks.. Then if you need to edit only one side of the travel, just hold the stick to that side, as Kilrah suggested above.

João

Sent from my thor using Tapatalk

openrcforums

9xPro dr/expo setting quantities

9xPro dr/expo setting quantities

Re: 9xPro dr/expo setting quantities

Re: 9xPro dr/expo setting quantities