9xPro dr/expo setting quantities

Programing help and example for all firmwares based on thus's th9 firmware.
Post Reply
denvoyager
Posts: 7
Joined: Sun Jan 10, 2016 8:52 am
Country: -

9xPro dr/expo setting quantities

Post by denvoyager » Sun Jun 25, 2017 6:40 am

Hi, everyone,
I'm setting up my 9xPro, and I am at the 'setting D/R and Expo' page. I'm using the 'RUD' setting.
In expo,I can adjust the right hand 'set' i.e. the upper part of the graph line, but don't know how to move the cursor to the left-hand number,i.e. the lower part of the graph.
I cannot reset the 'Hi' at all, How do I change that,please.Help!?please!
Den, Wales

User avatar
Kilrah
Posts: 9495
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: 9xPro dr/expo setting quantities

Post by Kilrah » Sun Jun 25, 2017 7:53 am

Hold the stick on the relevant side.

User avatar
jhsa
Posts: 17722
Joined: Tue Dec 27, 2011 5:13 pm
Country: Germany

Re: 9xPro dr/expo setting quantities

Post by jhsa » Sun Jun 25, 2017 8:56 am

Without holding the stick to one side both sides should change values together.. If that is not happening, please calibrate the sticks.. Then if you need to edit only one side of the travel, just hold the stick to that side, as Kilrah suggested above.

João

Sent from my thor using Tapatalk

My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9

Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW

Post Reply

Return to “er9x / gruvin9x / th9 based firmwares”