Code: Select all
=================================================================================
Started AVRDUDE
/usr/bin/avrdude -c usbasp -p m64 -B 10 -U eeprom:w:/tmp/temp.bin:r
=================================================================================
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.00s
avrdude: Device signature = 0x000102
avrdude: Expected signature for ATMEGA64 is 1E 96 02
Double check chip, or use -F to override this check.
avrdude done. Thank you.
=================================================================================
AVRDUDE done - exit code 1
=================================================================================
TX: 9x with Smartieparts board.
I actually captured the output from the firmware flash and it's
Code: Select all
=================================================================================
Started AVRDUDE
/usr/bin/avrdude -c usbasp -p m64 -B 10 -U flash:w:/tmp/flash.hex:i
=================================================================================
avrdude: set SCK frequency to 93750 Hz
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.00s
avrdude: Device signature = 0x1e9602
avrdude: NOTE: FLASH memory has been specified, an erase cycle will be performed
To disable this feature, specify the -D option.
avrdude: erasing chip
avrdude: set SCK frequency to 93750 Hz
avrdude: reading input file "/tmp/flash.hex"
avrdude: writing flash (50518 bytes):