Telemetry values all reading zero
Posted: Sat Sep 13, 2014 11:49 am
I have had the DSR-II working well for a while but suddenly it's not working.
I had Tx, Rx and voltage readings working on my 9x screen but now all reading 0.0. Not sure why. I'm using to fly a dji multicopter and otherwise it's all working fine. And weirdly my voltage readings which I had set actually appear to still work. I set an orange warning - single beep for below 10.8v and red warning - double beep for below 10.5v. These warnings come at the expected time even though the screen shows 0.0 on all readings.
How do I get these readings back? I must have changed a setting somewhere with out realising perhaps?
Thanks for any pointers here folks!
I had Tx, Rx and voltage readings working on my 9x screen but now all reading 0.0. Not sure why. I'm using to fly a dji multicopter and otherwise it's all working fine. And weirdly my voltage readings which I had set actually appear to still work. I set an orange warning - single beep for below 10.8v and red warning - double beep for below 10.5v. These warnings come at the expected time even though the screen shows 0.0 on all readings.
How do I get these readings back? I must have changed a setting somewhere with out realising perhaps?
Thanks for any pointers here folks!