Page 1 of 1
d/r rudder using throttle as switch
Posted: Sat Dec 10, 2016 6:41 am
by davejomac
I have just got my e9x. Older jr radios enabled d/r rudder control by throttle. ie high rate rdr at low thr and low rate rdr at high thr.Any help appreciated.Dave
Re: d/r rudder using throttle as switch
Posted: Sat Dec 10, 2016 10:27 am
by MikeB
You need to configure a logical switch, something like:
L1 v>val Thr 0
(Throttle goes from -100% to +100% so greater than 0 is above half throttle).
Now, just use L1 as the switch to enable the d/r setting.
If needed, it is posible to make the d/r amount vary progressively with the throttle setting.
Mike.
Re: d/r rudder using throttle as switch
Posted: Sat Dec 10, 2016 11:56 am
by jhsa
That progressive example is in the er9x manual..
Can't post a link at the moment..
João
d/r rudder using throttle as switch
Posted: Sat Dec 10, 2016 1:55 pm
by Daedalus66
Re: d/r rudder using throttle as switch
Posted: Sat Dec 10, 2016 2:37 pm
by jhsa
Thank you..
João