Page 1 of 1

Aux 3 switch problems .

Posted: Sat Jul 26, 2014 8:51 pm
by strilen
I have flashed my Turnigy 9xr with open Tx ver: 2.0.7
The three way switch AUX 3 is only showing ID0 in the first pos. ID1 in next pos .but will not show ID2 in last pos., showing ID1 here too.
I have change the switch , checked both and they are OK .
Also checked the wiring , OK .
I also flashed with ver: 2.0.8 but still same problem.
I also have tryed to find with older vers. but ver. 2.0.8 is allwys coming up .
Is there somebody who has the same trouble and has find a solution ?
Or, can work it out for me ?

Re: Aux 3 switch problems .

Posted: Sun Jul 27, 2014 7:36 am
by Kilrah
Would be worth checking the switch's wiring all the way from it to the processor. There's likely a broken connection in the ID2 line.

Sent via mobile

Re: Aux 3 switch problems .

Posted: Sun Jul 27, 2014 9:30 am
by strilen
OK, I will do an better checking of the wiring all the way .
Thanks for your reply .

Re: Aux 3 switch problems .

Posted: Sun Jul 27, 2014 12:06 pm
by strilen
Have fixed the problem .
It was one wire from the 3 way switch who ad failed in the 10 pole plug going to main board ( bad work from factory ) .
Now i want to find the mark and discription of the plugs and crimp terminal used on the main board .
Anybody know ?