Curve and switch in mix cause servo twitch

General Information & Rules
Post Reply
Dobbo14
Posts: 1
Joined: Wed Apr 11, 2018 4:51 pm
Country: -

Curve and switch in mix cause servo twitch

Post by Dobbo14 »

I am using an X9D plus with OpenTX 2.2.1.
I have set up a Thr to Ele mix using a curve CV1, it is fairly linear with a max of 8%. I am using a logical switch L04 to control throttle use and also to control the mix. i.e. I don't want the mix working if the throttle isn't.
L04 can only be true if SF↑
If L04 is true the mix works as required. However if I move SF (which changes L04 to false) the elevator channel jumps to +100% or -100% before it jumps back to the required low throttle value. This happens on the simulator and the model.
Is there a problem in OpenTX 2.2.1 or is it me?
I can avoid the problem by removing the curve and replacing it with Thr Weight 4% Offset 4% but I would prefer to have the flexibility of the Curve.

Post Reply

Return to “General Information & Rules”