Page 1 of 1
9Xtreme and Multiprotocol Module With STM chip
Posted: Wed Jan 11, 2017 2:52 pm
by jhsa
Mike, I am looking at building a Multiprotocol with a STM32 chip. The module uses a "SN74LVC2G00DCTR DUAL INPUT POSITIVE-NAND GATE". I have been told that this chip is needed because of the Taranis radio. I am planning to install this module as internal in my 9XT radio, and use COM2 for the telemetry.. My question is, do I need this chip with the 9XT??
Thank you
João
Re: 9Xtreme and Multiprotocol Module With STM chip
Posted: Wed Jan 11, 2017 4:06 pm
by MikeB
If that is used to invert the telemetry output, then, for COM2 on a 9Xtreme, it is not needed. It would be needed for COM1.
You could fit it, then add a link to select the non-inverted or the inverted output.
Mike.
Re: 9Xtreme and Multiprotocol Module With STM chip
Posted: Wed Jan 11, 2017 4:12 pm
by jhsa
The problem is that I couldn't easily find the IC at a good price. As I said the module will be installed inside the radio, so it will use COM2 which according to you is fine without the inverter. COM1 is used by the module bay telemetry.
If really needed, I could use a transistor instead of that IC, right?
Thanks
João
Re: 9Xtreme and Multiprotocol Module With STM chip
Posted: Wed Jan 11, 2017 4:28 pm
by Kilrah
Yes, the IC is used so that inversion can be enabled/disabled by software.
Re: 9Xtreme and Multiprotocol Module With STM chip
Posted: Wed Jan 11, 2017 4:41 pm
by jhsa
Kilrah wrote:Yes, the IC is used so that inversion can be enabled/disabled by software.
Yes, of course.. I understand.. Just wanted to know if it was really needed for the 9XT. It probably would, if I wanted to use the module in different radios, but as it will be installed internally, it is not needed, according to what Mike said..
Thanks
João
Re: 9Xtreme and Multiprotocol Module With STM chip
Posted: Wed Jan 11, 2017 5:09 pm
by Kilrah
I was answering your question about replacing it with a transistor... already fogot you'd asked it?
Re: 9Xtreme and Multiprotocol Module With STM chip
Posted: Wed Jan 11, 2017 6:00 pm
by jhsa
Oh, ok, I misunderstood your post then, I do apologize.. Need some beer obvoiusly
João
Re: 9Xtreme and Multiprotocol Module With STM chip
Posted: Wed Jan 11, 2017 9:32 pm
by OctavioS
jhsa wrote:Mike, I am looking at building a Multiprotocol with a STM32 chip. The module uses a "SN74LVC2G00DCTR DUAL INPUT POSITIVE-NAND GATE". I have been told that this chip is needed because of the Taranis radio. I am planning to install this module as internal in my 9XT radio, and use COM2 for the telemetry.. My question is, do I need this chip with the 9XT??
Thank you
João
Is it really worth all the work, espacially with such
cheap alternatives?
Re: 9Xtreme and Multiprotocol Module With STM chip
Posted: Wed Jan 11, 2017 9:39 pm
by Kilrah
That's nRF only.
Re: 9Xtreme and Multiprotocol Module With STM chip
Posted: Wed Jan 11, 2017 10:07 pm
by jhsa
OctavioS wrote:
Is it really worth all the work, espacially with such
cheap alternatives?
Yep
João