I've realized while reviewing production data that I neglected to specify that the white wire goes to pin X and the black wire goes to pin Y. I should have, but all I told them was that "one wire is black, one is white". They *probably* produced the 1000 sets consistently, but I guess I'm not sure that's the case. So I'm asking you... is your wire like what is shown here?
If you think your connector is NOT as shown here (and you haven't gone and swapped any wires yourself), I'd appreciate you posting a picture.
My expectation is that 100% of you have it the same as shown. If not, then documentation is going to have to be worded appropriately.
Black wire, white wire... the FrSky Cable Question
- bob195558
- Posts: 2377
- Joined: Sun Dec 16, 2012 7:24 pm
- Country: United States
- Location: New England, Vermont
- Contact:
Re: Black wire, white wire... the FrSky Cable Question
Hi Steven,
Much time has past and you have telemetry wire colors at 100% same all the time!
Bob B.
Much time has past and you have telemetry wire colors at 100% same all the time!
Bob B.
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).