No Custom Function for the ersky9xr?

[theemoarsonist]

Hi,

I'm very sorry if this is a stupid question. I'm just a newbie on the hobby

I'm trying to set up my trn switch to read out the Vfas voltage (I also wanted to assign a switch to read out the RSSI), but I can't seem to find where.
It's not in the logical switch
it's not in the safety switches
it's not in the voices.

I have successfully setup warning whenever my RSSI and voltage is low but it would be nice if I can hit a switch and get an exact readout of the value.
I know this is possible in the Taranis, and possibly on er9x, but I can't find it on the 9xr pro
My FW is 220 on the 9xr pro with XJT module running SBUS on a naze32 rev6b.

Thanks a lot to whomever can help me!!

[jhsa]

First of all, Vfas doesn't exist in ersky9x, only openTX
In ersky9x is called "FasV".

Also, in ersky9x you DO NOT need a logical switch or a safety switch. All is done in the "Voice" menu. All you need to create alarms is in just one place..

So as an example create a new voice alarm, for example "VA1"
Now to announce FasV when turning the TRN switch ON:

You can also play a voice file before or after the FasV value. Something like "Flight Battery, 12.2 Volts"

Or Create a low battery alarm, when the voltage goes below a certain value.

Just below my posts, there are a couple links. One of them take you to a video playlist with some ersky9x tutorials.. A couple of these are about the voice menu..

João

[theemoarsonist]

First of all, Vfas doesn't exist in ersky9x, only openTX
In ersky9x is called "FasV".

WAAA I'm very sorry for getting my terminologies wrong. I noticed it is FasV indeed.

Also, in ersky9x you DO NOT need a logical switch or a safety switch. All is done in the "Voice" menu. All you need to create alarms is in just one place..

Oh, so those logical and safety switches are just for redundancy/legacy features? That's neat!

I think I get it now. If I do not put function and value, it will just play the value of the source. That made so much sense oh my god!


Another question, totally unrelated:
Whenever I turn off the transmitter, I lose my telemetry and I have to go to Telemetry>Invert COM 1>then hit the checkbox on, then off again, and then I get my telemetry back. a bug maybe? BTW thanks a lot for your input it helped a lot

[MikeB]

Check this post: viewtopic.php?f=123&t=9526&hilit=rtc#p122263.

Mike.