I want to make a switch that puts the OSD into edit mode. Which is Throttle middle, yaw right, pitch full. How can I make a switch that does this?
Thanks,
CP
How to make switch that overrides multiple channels?
-
- Posts: 25
- Joined: Tue Mar 22, 2016 12:32 am
- Country: -
- MikeB
- 9x Developer
- Posts: 17992
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: How to make switch that overrides multiple channels?
For any channel you may add a mix line at the end of the mixes for that channel. Make it of type "Replace", the source = FULL, the weight the output value you require and the switch whatever switch you want to set the channel to this value.
So if on your yaw channel you probably have a mix like:
+100% Rud
Simply add:
R +100% FULL switch(RUD)
on that channel
Another way would be to use a Safety switch to provide the override.
Mike.
So if on your yaw channel you probably have a mix like:
+100% Rud
Simply add:
R +100% FULL switch(RUD)
on that channel
Another way would be to use a Safety switch to provide the override.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!