9xrPro r221 Protocol Module selection / Power

ersky9xr is the port of the er9x firmware to the 9XRPRO radio.
Post Reply
Painlesstom
Posts: 3
Joined: Thu Apr 05, 2018 12:53 pm
Country: United States
Contact:

9xrPro r221 Protocol Module selection / Power

Post by Painlesstom »

I've got two modules (OrangeRX Dsm2/Dsmx selectable) that I use to get 16 channels, but I don't need them both on for every model. Each model I can goto Protocol and disable the Internal module, leaving only the model I wish to use it enabled. But after power cycling the TX the internal module doesn't power up. I have to have the internal module enabled in EVERY model before it will power up. Not the end of the world, but it would be nice to see the firmware enable that module to be turned on and off automatically as I switch between models. Anyone else experience this, solutions?
Six 9XR's w/ PR10 Gimbals
Two 9XR Pro's w/ PR10 Gimbals / Dual Modules

User avatar
jhsa
Posts: 19480
Joined: Tue Dec 27, 2011 5:13 pm
Country: Germany

Re: 9xrPro r221 Protocol Module selection / Power

Post by jhsa »

The 9XR-PRO needs extra hardware to be able to switch the power to the modules, controlled by the firmware.
I did design a circuit a while ago that does this.
Did you install some hardware to switch the power to the modules?

João


My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9

Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
Post Reply

Return to “ersky9xr”