I used the reset button on the bottom of my 9XR Pro (next to the usb and SD card slot) thinking not knowing it would erase the Atmel chip.
Pc recognized few times then there was not recognition at all.I need help to flash chip with new firmware.
Pc is not recognizing turnigy 9xr pro after erasing atmel chip
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Pc is not recognizing turnigy 9xr pro after erasing atmel chip
Go here: viewtopic.php?f=123&t=5581#p79505, and download "9XR Pro Using SAM-BA to restore bricked Tx 2014-02-12.pdf".
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: Pc is not recognizing turnigy 9xr pro after erasing atmel chip
The atmel chip is erased and there is blank blue screen. There is not sound when I connect to Pc nor recognition
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Pc is not recognizing turnigy 9xr pro after erasing atmel chip
Make sure you plug the USB connector in fully. It may take a significant push and then 'click' into place.
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: Pc is not recognizing turnigy 9xr pro after erasing atmel chip
I connected it fully still no answer and also tried on other pc,no result
Re: Pc is not recognizing turnigy 9xr pro after erasing atmel chip
Did you try another usb cable? Is the RESET button on back of tx free or stuck?
Re: Pc is not recognizing turnigy 9xr pro after erasing atmel chip
i tried with different cable and reset button is free
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Pc is not recognizing turnigy 9xr pro after erasing atmel chip
The "SAM-BA" boot code in the processor is in ROM and should therefore respond to a USB connection.
Were you having problems before you used the reset button?
You could try repeating the reset operation with the button, then using the USB.
Mike.
Were you having problems before you used the reset button?
You could try repeating the reset operation with the button, then using the USB.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: Pc is not recognizing turnigy 9xr pro after erasing atmel chip
After resetting once again the usb is working
Thanks Mike
Thanks Mike