Hi,
I have connected X8R by SBUS to NAZE32 and fine with a bit problem of left gimbal stick. But i can't to get telemetry using 5rx-6tx pins softserial naze32 connected to signal pin of smarport of X8R. I only got RSSI parameter but no more.
Is neccesary special firmware or special configuration for work it?
Thanks.
Problem Telemetry 9XR PRO+X8R+NAZE32
-
- Posts: 12
- Joined: Thu Apr 09, 2015 8:18 am
- Country: -
Re: Problem Telemetry 9XR PRO+X8R+NAZE32
Not on the radio apart from running a new sensor discovery if you're on 2.1, but on the Naze yes there are a few parameters to set up.
-
- Posts: 12
- Joined: Thu Apr 09, 2015 8:18 am
- Country: -
Re: Problem Telemetry 9XR PRO+X8R+NAZE32
Thanks Kilrah,
After going crazy a long time, I managed to get some parameters activating "Protocol PXX D16" and disconnecting the cable between the module XJT (RX / TX) and port Futaba (trainer COM2).
I added the GPS coordinates naze32 to have and there seems to conflict using "investment telemetry ON" and GPS.
I will continue investigating ...
Thanks for all.
After going crazy a long time, I managed to get some parameters activating "Protocol PXX D16" and disconnecting the cable between the module XJT (RX / TX) and port Futaba (trainer COM2).
I added the GPS coordinates naze32 to have and there seems to conflict using "investment telemetry ON" and GPS.
I will continue investigating ...
Thanks for all.