Greetings All,
I've been using a TH9X and ER9X with eePe for years, but I'm new to the 9XR pro and the new Frsky XJT RX's. I've got the RX and TX bound, and I'm getting telemetry from the RX. But, I can't get any of the servos to respond. They all get power and center up when the battery is connected. There is a green light on the RX. But, no control of the servos. I'm not sure where to go next.
Thanks,
Todd
9XR Pro and X8R bound but no servo movement
-
- Posts: 12
- Joined: Mon Dec 04, 2017 5:59 am
- Country: -
-
- Posts: 1844
- Joined: Tue Dec 27, 2011 8:22 pm
- Country: -
- Location: Ottawa
9XR Pro and X8R bound but no servo movement
So you’ve got an XJT module and are linking with an X8R receiver.
What version of ErSky9x?
Do you have XJT selected under Protocol, Type D16?
Sent from my iPhone using Tapatalk
What version of ErSky9x?
Do you have XJT selected under Protocol, Type D16?
Sent from my iPhone using Tapatalk
-
- Posts: 12
- Joined: Mon Dec 04, 2017 5:59 am
- Country: -
Re: 9XR Pro and X8R bound but no servo movement
Hi,
I've got r220 installed. And, Protocol is XJT and type D16. And, I'm using eepeSky to program.
I've got r220 installed. And, Protocol is XJT and type D16. And, I'm using eepeSky to program.
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: 9XR Pro and X8R bound but no servo movement
Check you have mixes configured for the first 4 channels, and that the bars move on the "bars" screen.
Did you bind using the "bind" option in the protocol menu?
Mike.
Did you bind using the "bind" option in the protocol menu?
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
-
- Posts: 12
- Joined: Mon Dec 04, 2017 5:59 am
- Country: -
Re: 9XR Pro and X8R bound but no servo movement
Yes, channel mixes are configured and all the bars move correctly. I bound it using the FS button on the module and the receiver. I've also done it using the bind option in the protocol menu.
Todd
Todd
-
- Posts: 12
- Joined: Mon Dec 04, 2017 5:59 am
- Country: -
Re: 9XR Pro and X8R bound but no servo movement
Well, I think I got it sorted. But, I'm not sure why. I just went through the binding procedure again through protocol menu. It seems to be working now. Any thoughts on this?
Thanks,
Todd
Thanks,
Todd