openrcforums

Hi..can someone help me solve the problem.
I flashed 9XRPRO with opentx9xrpro 2.2.0 N367 firmware and can't get any telemetry data.The module is DJT, Rx is D4R-II.Also with the same setup I got telemetry on my Taranis X9D and I got telemetry on 9XRPRO with ersky9x firmware.So the wiring is not a problem.In telemetry screen I choose frsky D cable and inverted option.Did I miss something or it's not supported in opentx firmware yet?

Try without the inverted option.

Mike.

MikeB wrote: ↑Mon May 15, 2017 12:05 am Try without the inverted option.

Mike.

Tried all combinations without success

Any other suggestions anybody?

Suggestions:
1) Maybe go back to erSky9x to see if D-Series (PPM protocol) DJT telemetry still works when using erSky9x firmware.
2) Purchase the XJT module to be able to try PXX protocol.

Bob B.

bob195558 wrote: ↑Mon May 15, 2017 12:25 pm Maybe go back to erSky9x to see if D-Series (PPM protocol) DJT telemetry still works when using erSky9x firmware.
Purchase the XJT module to be able to try PXX protocol.

Bob B.

I wrote before that telemetry worked with ersky9x firmware on my 9xrpro using DJT module and D4R-II rx.. just want to get a clue why it's not working on opentx (9xrpro) firmware and 9xrpro.This is just my older setup. My new setups all works on Taranis internal or external XJT module and x4r-sb or xsr using sbus..tnx for comment,Bob

9xr pro and djt with with telemetry cable is not working on opentx 2.2.0. I've gone into the source code and the serial port 2 code in the sky9x target is non functional. I suspect it was broken when taranis specific changes were made. I've fixed some at least gotten rssi to work but I need to polish the code a before I make a pull request. I could be a while.